Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Charging equipment faultTry different charging equipment(CP_a004)

Tesla Model 3 2017-2022 Owner's Manual / Consumer Information / Troubleshooting Alerts / Charging equipment faultTry different charging equipment(CP_a004)

The charge port is unable to detect whether a charge cable is inserted or the type of charge cable connected.

If this alert appears while a charge cable is connected, it should be determined whether the issue is caused by the charging equipment or the vehicle. Try charging the vehicle using different external charging equipment (charge cable, charging station, charging stall, etc.).

If this alert appears while a charge cable is not connected or if the issue is suspected to be with the vehicle, inspect the charge port inlet and the charge cable connector for any obstructions (use a flashlight as necessary).

Debris, moisture, and/or foreign objects present in the charge port inlet or the charge cable connector can prevent the charge port from properly detecting charge cables. If any obstruction is found:

  1. Remove the debris / foreign object or dry any moisture.
  2. Try re-inserting the cable into the charge port. Charging should now be possible.

Service should only be scheduled if any of the following conditions are present:

For more information on charging, see Charging Instructions

Unable to chargeCheck charging equipment(CP_a046)

The charge port is unable to detect whether a charge cable is inserted or the type of charge cable connected.

If this alert appears while a charge cable is connected, it should be determined whether the issue is caused by the charging equipment or the vehicle. Try charging the vehicle using different external charging equipment (charge cable, charging station, charging stall, etc.).

If this alert appears while a charge cable is not connected or if the issue is suspected to be with the vehicle, inspect the charge port inlet and the charge cable connector for any obstructions (use a flashlight as necessary).

Debris, moisture, and/or foreign objects present in the charge port inlet or the charge cable connector can prevent the charge port from properly detecting charge cables. If any obstruction is found:

  1. Remove the debris / foreign object or dry any moisture.
  2. Try re-inserting the cable into the charge port. Charging should now be possible.

Service should only be scheduled if any of the following conditions are present:

For more information on charging

Troubleshooting Alerts
...

AC charging interruptedCheck power source or charging equipment(CP_a055)
Charging stopped because communication between the vehicle and the external charging equipment was interrupted. Confirm whether the external charging equipment is powered by looking for any sta ...

Other materials:

Ignition Switch Inspection [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the ignition switch.. 4. Verify that the continuity between the ignition switch terminals is as indicated in the table. If not as indicated in the table, replace the ignition switch. ...

Radiator Drain Plug Replacement [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Oil Seal (Differential) Replacement [G35 M R]
1. On level ground, jack up the vehicle and support it evenly on safety stands. 2. Remove the aerodynamic under cover No.2.. 3. Drain the oil from the transaxle.. 4. Remove the front splash shield.. 5. Separate the drive shaft and joint shaft from the transaxle.. 6. Remove the oil seals u ...

2016-2022 Copyright www.mazda3tech.com