Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Jacking and Lifting

Follow the steps below to lift Model 3. Ensure that any non-Tesla repair facility is aware of these lifting points.

  1. Position Model 3 centrally between the lift posts.
  2. Position the lift arm pads under the designated body lift points at the locations shown.

Warning: DO NOT position the lift arm pads under the Battery or side rails, as shown in red.

Jacking and Lifting


  1. Adjust the height and position of the lift arm pads to ensure that they are correctly located.
  2. With assistance, raise the lift to the desired height, ensuring the lift arm pads remain in their correct positions.
  3.  Engage any lift safety locks. Follow the lift manufacturer's instructions.

Warning: Never raise Model 3 when the charge cable is connected, even if charging is not in progress.

Warning: Do not work on an incorrectly supported vehicle. Doing so can cause serious damage, bodily injury, or death.

Caution: DO NOT lift from under the Battery or side rails. Place the lift arm pads under the designated body lift points only. The locations shown are the only approved lifting points for Model 3.

Lifting at any other points can cause damage. Damage caused by incorrectly lifting Model 3 is not covered by the warranty.

Topping Up Windshield Washer Fluid
The only reservoir into which you can add fluid is the windshield washer fluid reservoir, which is located behind the front trunk. When the level is low, a message displays on the touchscreen. ...

Parts and Accessories
...

Other materials:

Timing Chain Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the wiring harness. 5. Remove the ignition coils.. 6. Remove the spark plugs.. 7. Remove the ventilation hose. 8. Remove the coolant reserve tank with the hose still c ...

Brake/Clutch Fluid
Inspecting Brake/Clutch Fluid Level WARNING If the brake/clutch fl uid level is low, have the brakes inspected: A low brake/clutch fl uid level is dangerous. A low level could indicate brake lining wear or a brake system leak which could cause the brakes to fail and lead ...

Door Lock Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Remove the front door trim.. 4. Remove the front inner handle.. 5. Inspect for continuity between the door lock switch terminals using an ohmmeter. If not as indicated in the table, replace the door lock ...

2016-2022 Copyright www.mazda3tech.com