Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Opening Hood with No Power

In the unlikely event that Model 3 has no 12V power, you will be unable to open the front trunk using the touchscreen, key fob, or mobile app. To open the front trunk in this situation:

Note: The following will not open the front trunk if Model 3 is locked and has 12V power.

  1. Locate an external 12V power supply (such as a portable jump starter).
  2. Release the tow eye cover by pressing firmly on the top right perimeter of the cover until it pivots inward, then gently pulling the raised section toward you.

    Note: Depending on production date, either the positive or negative terminal may be attached to the tow eye cover.

Opening Hood with No Power


  1. Pull the two wires out of the tow eye opening to expose both terminals.

Opening Hood with No Power


  1. Connect the 12V power supply's red positive (+) cable to the red positive (+) terminal.
  2. Connect the 12V power supply's black negative (-) cable to the black negative (-) terminal.

Opening Hood with No Power


Note: Applying external 12V power to these terminals only releases the hood latches. You cannot charge the 12V battery using these terminals.

  1. Turn on the external power supply (refer to the manufacturer's instructions). The hood latches are immediately released and you can now open the hood to access the front trunk area.
  2. Disconnect both cables, beginning with the black negative (-) cable.
  3. If pulling Model 3 onto a flatbed truck, do not replace the tow eye cover yet.

    Otherwise, replace the tow eye cover by inserting the wires into the tow eye opening and aligning the tow eye cover into position and turning it into place.

Opening Hood with No Power


Opening/ Closing
Opening To open the front trunk: Ensure that the area around the hood is free of obstacles.  Touch the associated OPEN button on the touchscreen, double-click the front trunk button ...

Interior Storage and Electronics
...

Other materials:

Initial Learning [Fw6 A EL]
Introduction If the control valve body and oil pressure switch are replaced, always perform the initial learning. If the initial learning is not completed, engine rev-up may occur or shift shock may increase. DTC P06B8:00 is displayed while the initial learning has not been implement ...

Warning Lights
These lights turn on or flash to notify the user of the system operation status or a system malfunction. Signal Warning Lights Master Warning Light *1 Brake System Warning Light *1*2 ABS Warning Light *1 Charging System Warnin ...

Seat Warmer Unit Removal/Installation
Removal WARNING: Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings before handling a front seat (with built-in side air bag).. CAUTION: After removing a f ...

2016-2022 Copyright www.mazda3tech.com