Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Opening the Charge Port

The charge port is located on the left side of Model 3, behind a door that is part of the rear tail light assembly. Before charging, park Model 3 to ensure that the charge cable easily reaches the charge port.

With Model 3 unlocked (or an authenticated phone is within range) and in Park, press and release the button on the Tesla charge cable to open the charge port door.

Opening the Charge Port


You can also open the charge port door using any of these methods:

Note: The following image is provided for demonstration purposes only. Depending on market region, your charge port may be slightly different.

Opening the Charge Port


Note: The Tesla "T" lights up white when you open the charge port door. If you do not insert a charge cable into the charge port within a few minutes after opening the charge port door, the charge port door closes. If this happens, use the touchscreen to open the charge port door again

Caution: Do not try to force the charge port door open.

Plugging In

If desired, use the touchscreen to change the charge limit and the charging current

To charge at a public charging station, plug the appropriate adapter into the vehicle's charging port, and then connect the station's charging connector to the adapter. The most commonly used adapter(s) for each market region are provided. Depending on the charging equipment you are using, you may need to start and stop charging using a control on the charging equipment.

If you are using the Mobile Connector, plug it into the power outlet before plugging it into Model 3.

Align the connector to the charge port and insert fully. When the connector is properly inserted, charging begins automatically after Model 3:

Note: Whenever Model 3 is plugged in but not actively charging, it draws energy from the wall outlet instead of using energy stored in the Battery. For example, if you are sitting in Model 3 and using the touchscreen while parked and plugged in, Model 3 draws energy from the wall outlet instead of the Battery.

Caution: The connector end of the charge cable can damage the paint if dropped onto the vehicle.

Charging Instructions
...

During Charging
During charging, the charge port light (the Tesla "T" logo) pulses green, and the touchscreen displays the charging status. The frequency at which the charge port light pulses slows down ...

Other materials:

Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]
ECT Sensor No.1 Resistance inspection WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Drain the engine coolant.. 4. R ...

Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge. 2. Verify that the clearance. If not within the specification, remove the pressure plate and adjust the clearance by changing the shim (0.2 mm {0. ...

Ventilator Grille Removal/Installation
Side Ventilator grille 1. Through the wiring harness into the position shown in the figure, remove the side ventilator grille in the direction of arrow. 2. When installing the side ventilator grille, push it for the dashboard. Center Ventilator grille 1. Disconnect the negative battery c ...

2016-2022 Copyright www.mazda3tech.com