Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Polishing, Touch Up, and Body Repair

Tesla Model 3 2017-2022 Owner's Manual / Maintenance / Cleaning / Polishing, Touch Up, and Body Repair

To preserve the cosmetic appearance of the body, you can occasionally treat the paint surfaces with an approved polish containing:

Regularly inspect the exterior paint for damage. Treat minor chips and scratches using a paint touch-up pen (available for purchase from Tesla). Use the touch-up pen after washing but before polishing or waxing.

Repair rock chips, fractures or scratches

Caution: Do not use cutting pastes, color restoration compounds, or polishes containing harsh abrasives. These can scour the surface and permanently damage the paint.

Caution: Do not use chrome polish or other abrasive cleaners.

Using a Car Cover

To preserve the cosmetic appearance of the body when Model 3 is not being used, use a genuine Tesla car cover. Car covers can be purchased from Tesla.

Using a Car Cover


Caution: Use only a Tesla-approved car cover when Model 3 is plugged in. Using a non-Tesla car cover can prevent the Battery from being adequately cooled during charging.

Floor Mats

To extend the life of your carpet and make them easier to clean, use genuine Tesla floor mats. Maintain floor mats by regularly cleaning them and checking that they are properly attached. Replace floor mats if they become excessively worn.

Warning: To avoid potential interference with a foot pedal, ensure that the driver's floor mat is securely fastened, and never place an additional floor mat on top of it.

Floor mats should always rest on top of the vehicle carpeting surface and not on another floor mat or other covering.

Cleaning the Interior
Frequently inspect and clean the interior to maintain its appearance and to prevent premature wear. If possible, immediately wipe up spills and remove marks. For general cleaning, wipe interior su ...

Wiper Blades and Washer Jets
Checking and Cleaning Wiper Blades Periodically clean the edge of the wiper blades and check the rubber for cracks, splits, and roughness. If damaged, replace the blade immediately to prevent dam ...

Other materials:

Refrigerant Pressure Sensor Inspection [Manual Air Conditioner]
MZR 2.0, MZR 2.5 1. Install the manifold gauge. 2. Verify the high-pressure side reading of the manifold gauge. 3. Measure the terminal voltage of the climate control unit. 1G,1H and 2J 4. Verify that below graph as measure the terminal voltage 2J. 5. Follow the climate control ...

Map Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped fastener remover into the service hole and pry with the screwdriver in the direction shown by the arrow to remove the lens. 3. Remove the map light bulb. 4. Install in the reverse order of removal. ...

Washer Motor Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the front mudguard (RH).. 3. Remove in the order indicated in the table. 1 Windshield washer hose 2 Washer motor connector 3 Washer motor ...

2016-2022 Copyright www.mazda3tech.com