Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Secure the Tires

The vehicle's tires must be secured onto the truck using the eight-point tie-down method.

Caution: Attaching the tie-down straps to the chassis, suspension or other parts of the vehicle's body may cause damage.

Secure the Tires


If Vehicle Has No Power

If Model 3 has no 12V power, perform the following steps to open the hood or jump start the auxiliary 12V battery.

Jump Starting the 12V Battery

Caution: Model 3 cannot be used to jump start another vehicle. Doing so can result in damage.

Note: If jump starting Model 3 using another vehicle, refer to that vehicle manufacturer's instructions. The following instructions assume an external 12V power supply (such as a portable jump starter) is used.

Caution: Avoid short circuits when jump starting Model 3. Connecting cables to the wrong terminals, touching leads together, etc., can result in damage to Model 3.

  1. Open the hood
  2. Remove the maintenance panel by pulling it upwards to release the trim clips that hold it in place.

If Vehicle Has No Power


  1. Remove the cabin intake trim panel by pulling it upwards to release the trim clips that hold it in place.

If Vehicle Has No Power


  1. Connect the 12V power supply's red positive (+) cable to the red positive (+) terminal on the 12V battery.

Caution: To avoid damaging Model 3, do not allow the positive cable to contact other metal components, such as the battery tie-down bracket.

  1. Connect the 12V power supply's black negative (-) cable to the black negative (-) terminal on the 12V battery.

If Vehicle Has No Power


  1. Turn on the external power supply (refer to the manufacturer's instructions). Touch the touchscreen to wake it up.

Note: It may take several minutes to receive enough power to wake up the touchscreen.

  1. When external 12V power is no longer required, disconnect both cables from the terminals on the 12V battery, beginning with the black negative (-) cable.
  2. Replace the cabin intake trim panel by placing it back in its original location and pressing down until it is secure.
  3.  Replace the maintenance panel by placing it back in its original location and pressing down until it is secure.
  4.  Close the hood.
Activate Transport Mode
Transport Mode keeps the parking brake disengaged while winching Model 3 onto a flatbed truck. When active, Transport Mode displays a message indicating that the vehicle will remain free-rolling. ...

Consumer Information
...

Other materials:

Intermediate Sensor Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the intermediate sensor. a. Set the battery component (ex: battery, battery tray and PCM component) out of the way. b. Disconnect the intermediate sensor connector. c. Switch the ignition to ON (engine off). d. Measure the ...

Blower Motor Removal [Manual Air Conditioner]
NOTE: The blower motor is located on the A/C unit as shown in the figure. Perform the work from the front passenger side in the posture shown in the figure. 1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable. 3. Remove the following ...

Oil Pump Removal/Installation [Mzr 2.3 Disi Turbo]
WARNING: Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled. A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work ...

2016-2022 Copyright www.mazda3tech.com