Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Stopping or Canceling Smart Summon

Tesla Model 3 2017-2022 Owner's Manual / Autopilot / Smart Summon / Stopping or Canceling Smart Summon

Smart Summon stops Model 3 whenever you release the button on the mobile app. To resume the Smart Summon session, simply press the COME TO ME or GO TO TARGET button again.

Warning: Always anticipate when you need to stop Model 3. Depending on the quality of the connectivity between the phone and Model 3, there may be a slight delay between when you release the button and when the car stops.

Smart Summon cancels, and requires you to restart it, when:

Limitations

Smart Summon is unlikely to operate as intended in the following types of situations:

Note: Smart Summon is disabled if Model 3 is in Valet mode

Warning: The list above does not represent an exhaustive list of situations that may interfere with proper operation of Smart Summon. It is the driver's responsibility to remain in control of Model 3 at all times. Pay close attention whenever Smart Summon is actively moving Model 3 and stay prepared to take immediate action. Failure to do so can result in serious property damage, injury or death.

Using Smart Summon
Open the Tesla mobile app, and press SUMMON. Press the Smart Summon icon located in the center of the image of your Model 3. It may take several seconds for Smart Summon to start up. N ...

Lane Assist
The Autopilot cameras and ultrasonic sensors monitor the markers on the lane you are driving in as well as the areas surrounding Model 3 for the presence of vehicles or other objects. When an o ...

Other materials:

Visual and Audio Feedback
When you shift to Reverse, the Park Assist view displays on the touchscreen, showing objects that are in close proximity to the front and rear of Model 3. This view closes when you shift into Drive unless an object is detected close to the front of Model 3, in which case the Park Assist view c ...

Headliner Removal/Installation
1. Shift to the D (ATX) or 4th gear (MTX) position. (4SD) 2. Disconnect the negative battery cable.. 3. Remove the rain sensor cover. (Vehicles with auto light/wiper system). 4. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system) 5. Partially peel back the seaming ...

Rear Spoiler Removal/Installation
4SD 1. Remove the trunk lid trim.. 2. Remove the nuts. 3. While cutting the double-sided adhesive tape using a flathead screwdriver or a razor, separate the rear spoiler from the trunk lid. WARNING: Using a razor with bare hands can cause injury. Always wear gloves when usin ...

2016-2022 Copyright www.mazda3tech.com