Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Topping Up Windshield Washer Fluid

Tesla Model 3 2017-2022 Owner's Manual / Maintenance / Fluid Reservoirs / Topping Up Windshield Washer Fluid

The only reservoir into which you can add fluid is the windshield washer fluid reservoir, which is located behind the front trunk. When the level is low, a message displays on the touchscreen.

To top up the washer fluid:

  1. Open the hood.
  2. Clean around the filler cap before opening it to prevent dirt from entering the reservoir.
  3. Open the filler cap.
  4. While avoiding spilling, fill the reservoir until the fluid level is visible just below the filler neck. The reservoir has a capacity of 3.2 liters.

Topping Up Windshield Washer Fluid


  1. Wipe up any spills immediately and wash the affected area with water.
  2. Replace the filler cap.

Note: Some national or local regulations restrict the use of Volatile Organic Compounds (VOCs). VOCs are commonly used as antifreeze in washer fluid. Use a washer fluid with limited VOC content only if it provides adequate freeze resistance for all climates in which you drive Model 3.

Caution: Do not add formulated washer fluids that contain water repellent or bug wash. These fluids can cause streaking, smearing, and squeaking or other noises.

Warning: In temperatures below 40º F (4º C), use a washer fluid with antifreeze. In cold weather, using a washer fluid without antifreeze can impair visibility through the windshield.

Warning: Windshield washer fluid can irritate eyes and skin. Read and observe the instructions provided by the washer fluid manufacturer.

Removing the Maintenance Panel
To check fluid levels, remove the maintenance panel: Open the hood.  Pull the maintenance panel upward to release the clips that hold it in place. If checking the Battery coola ...

Jacking and Lifting
Follow the steps below to lift Model 3. Ensure that any non-Tesla repair facility is aware of these lifting points. Position Model 3 centrally between the lift posts. Position the lift arm p ...

Other materials:

Accessory Socket Inspection
Front 1. Disconnect the negative battery cable.. 2. Remove the upper panel.. 3. Remove the shift lever knob. (MTX). 4. Remove the selector lever knob. (ATX). 5. Remove the shift panel. 6. Remove the accessory socket (front). 7. Connect a tester as shown in the figure and verify that the ...

Adjuster Anchor Removal/Installation
WARNING: The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-pillar, disconnect the negative battery cable or work carefully, avoiding excessive impact to the lower part of the B-pillar. 1. Remove the following parts: a. Front sc ...

How Park Assist Works
Model 3 has several sensors designed to detect the presence of objects. When driving slowly in Drive or Reverse (for example, when parking), the sensors alert you if an object is detected in close proximity of your Model 3. Objects are only detected in the direction of the gear you selected; ...

2016-2022 Copyright www.mazda3tech.com