Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Turn Signals

The turn signals flash three times or continuously, depending on how far up or down you move the lever. Lightly push the turn signal lever up or down for a three-flash sequence. For a continuous signal, push the lever fully up or down.

Turn Signals


The turn signals stop operating when canceled by the steering wheel, by moving the lever in the opposite direction, or lightly pushing the lever in the same direction once more.

The corresponding turn signal
indicator lights up on the touchscreen when a turn signal is operating. Model 3 also emits a clicking sound.

Warning: If you have purchased an optional Autopilot package and Traffic- Aware Cruise Control is active, engaging a turn signal can cause Model 3 to accelerate when using Traffic-Aware Cruise Control in specific situations. If Autosteer is active on a vehicle with Auto Lane Change, engaging a turn signal may cause Model 3 to change lanes.

Hazard Warning Flashers

To turn on the hazard warning flashers, press the button located above the rear view mirror.

All turn signals flash. Press the button again to turn off the hazard warning flashers.

Hazard Warning Flashers


Note: Hazard warning flashers operate even when Model 3 cannot detect a key.

High Beam Headlights
Push the left-hand steering column lever away from you and release to turn the high beam headlights on continuously. To cancel, push the lever away from you again. To briefly flash the high beam ...

Car Status
...

Other materials:

Registering Your Vehicle in A Foreign Country (Except United States and Canada)
Registering your vehicle in a foreign country may be problematic depending on whether it meets the specific emission and safety standards of the country in which the vehicle will be driven. Consequently, your vehicle may require modifications at personal expense in order to meet the regulat ...

Dashboard Upper Panel Removal/Installation
Vehicles Without Bose® 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper column cover. b. Instrument cluster. c. Center panel. d. Center cover. 3. Remove the screw. 4. Pull up the dashboard upper panel in the direction of arrow shown in the figure, t ...

Clock Switch Inspection
NOTE: Clock switch built with the hazard warning switch. 1. Disconnect the negative battery cable.. 2. Remove the clock switch.. 3. Verify resistance between the clock switch terminals. If the resistance is not as specified, replace the clock switch. Between t ...

© 2016-2022 Copyright www.mazda3tech.com