Mazda 3 manuals

Tesla Model 3 2017-2022 Owner's Manual: Wipers and Washers

Wipers

To perform a single wipe with the windshield wipers, press and immediately release the button on the end of the left-hand steering column lever.

To adjust the continuous wiper settings, touch the windshield wiper icon located in the "Cards" area on the touchscreen. The wiper card displays the current state of the wipers.

Note: When you operate the wipers, the headlights automatically turn on (if they were not on already).

Caution: To avoid damaging the hood, ensure that the hood is fully closed before activating the windshield wipers.

Wipers


  1. Turn the wipers on or off.
  2.  Adjust the speed of the wipers.

Note: The AUTO setting is currently in BETA. If uncertain about using AUTO while in the BETA phase, Tesla recommends setting the wiper speed to one of the first four positions, as necessary.

Note: If the AUTO setting is selected but becomes unavailable, the wipers change to the manual setting (one of the first four positions) that is closest to the latest determined AUTO wiping frequency. If the latest wiping frequency cannot be determined, the wipers turn off.

Caution: Ensure the wipers are off before washing Model 3 to avoid the risk of damaging the wipers.

Periodically check and clean the edge of the wiper blades. If a blade is damaged, replace it immediately. For details on checking and replacing wiper blades

Caution: Remove ice from the windshield before turning the wipers on. Ice has sharp edges that can damage the rubber on the blades.

Caution: In harsh climates, ensure that the wiper blades are not frozen or adhered to the windshield.

Washers

Fully press and hold the button on the end of the left-hand steering column lever to spray washer fluid onto the windshield. While spraying the windshield, the wipers turn on.

After releasing the button, the wipers perform two additional wipes, then a third wipe a few seconds later.

Washers


Periodically top up washer fluid

Driving Status
When Model 3 is driving (or ready to drive), the touchscreen shows your current driving status and a real-time visualization of the road as detected by the Autopilot components. The visualization ...

Braking and Stopping
...

Other materials:

Assist Handle Removal/Installation
Assist Handle Removal 1. Insert a flathead screwdriver into the service hole and remove the assist handle covers. 2. Remove the assist handle in the direction of the arrow (1) and (2), while detach the clip. NOTE: Remove the assist handle by shaking it up and down. Ass ...

Illuminated Entry System
When the illuminated entry system operates, the overhead light (switch is in the DOOR position) turn on for: About 30 seconds after the driver's door is unlocked and the ignition is switched off. About 15 seconds after all doors are closed and the ignition is switched off. About 5 se ...

Oil Cooler Removal/Installation [Fw6 A EL]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover NO.2.. 4. Drain the ATF.. 5. Drain the engine coolant.. 6. Remove in the order indicated in the table. 1 Water hose (connected to the water pipe) ...

2016-2022 Copyright www.mazda3tech.com