Mazda 3 Service Manual: A/C

Rear Heat Duct Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper panel. b. Shift lever knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Consol ...

A/C Compressor Removal/Installation

1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Remove the aerodynamic under cover No.2.. 4. Remove the drive belt.. 5. Remove the water hose bracket. CAUTIO ...

Other materials:

Climate Control Unit Inspection [Full Auto Air Conditioner]
1. Remove the climate control unit with the connector connected.. 2. Switch the ignition to ON. 3. Connect the negative (-) lead of the tester to body ground. 4. By inserting the positive (+) lead of the tester into each climate control unit terminal, measure the voltage according to the ter ...

Sirius Satellite Radio Antenna Feeder Inspection
SIRIUS Satellite Radio Antenna Feeder No.1 NOTE: SIRIUS satellite radio antenna feeder No.1 is integrated with the dashboard wiring harness. 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Passenger-side front scuff plate. b. Passenger-side front ...

B Pillar Upper Trim Removal/Installation
1. Remove the following parts: a. Adjuster anchor cover. b. Upper anchor installation bolts on the front seat belt. c. Front scuff plate. d. Rear scuff plate. 2. Partially peel back the seaming welt. 3. Remove the B-pillar lower trim.. 4. Grasp the lower end of the B-pillar upper trim, ...