Mazda 3 Owners Manual: Accessory Sockets

Mazda 3 Owners Manual / Interior Features / Interior Equipment / Accessory Sockets

Only use genuine Mazdaaccessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).

Type A

The accessory sockets can be used regardless of whether the ignition is on or off.

Mazda 3. Accessory Sockets

Type B *

The ignition must be switched to ACC or ON.

With CD Player

Mazda 3. Accessory Sockets

Without CD Player

Mazda 3. Accessory Sockets

CAUTION

To prevent accessory socket damage or electrical failure, pay attention to the following:

Do not use accessories that require more than 120 W (DC 12 V, 10 A).
Do not use accessories that are not genuine Mazda accessories or the equivalent.
Close the cover when the accessory socket is not in use to prevent foreign objects and liquids from getting into the accessory socket.
Correctly insert the plug into the accessory socket.
Do not insert the cigarette lighter into the accessory socket.

Noise may occur on the audio playback depending on the device connected to the accessory socket.
Depending on the device connected to the accessory socket, the vehicle's electrical system may be aff ected, which could cause the warning light to illuminate. Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the ignition off . If the problem is not resolved, consult an Authorized Mazda Dealer.

NOTE To prevent discharging of the battery, do not use the socket for long periods with the engine off or idling.

Connecting the accessory socket

Open the lid.
Pass the connection plug cord through the cutout of the console and insert the plug into the accessory socket.

Mazda 3. Connecting the accessory socket

Illuminated Entry System

When the illuminated entry system operates, the overhead light (switch is in the DOOR position) turn on for: About 30 seconds after the driver's door is unlocked and the ignition is switched ...

Cup Holder

WARNING Never use a cup holder to hold hot liquids while the vehicle is moving: Using a cup holder to hold hot liquids while the vehicle is moving is dangerous. If the contents s ...

Other materials:

Rain Sensor Removal/Installation
1. Disconnect the negative battery cable.. 2. Spread open the rain sensor cover in the direction of the arrows and disengage tabs A to remove it. 3. Disconnect the rain sensor connector. 4. Slide rain sensor tab B in the direction of the arrow shown in the figure and detach tab B. ...

High Mount Brake Light Bulb Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the trunk lid trim.. 3. Remove in the order indicated in the table. 1 Connector 2 Socket 3 High-mount brake light bulb 4. Install in the rev ...

Voice Recognition (Type B)
In this section, the basic operation of the voice recognition is explained. Activating Voice Recognition Press the talk button. Ending Voice Recognition Use one of the following methods: Press the hang-up button. Say, “Cancel”. Operate the commander switch or the center display (only ...