Mazda 3 Service Manual: Afs (Adaptive Front Lighting System) Control Module Removal/Installation
NOTE:
-
Perform the auto leveling system initialization after newly replacing the AFS control module to assure that the auto leveling system operates correctly.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Passenger-side front scuff plate.
b. Passenger-side front side trim.
c. Dashboard under cover.
d. Glove compartment.
e. Passenger-side lower panel.
3. Remove in the order indicated in the table.
|
1 |
Nut |
|
2 |
Connector |
|
3 |
AFS control module |
4. Install in the reverse order of removal.
5. Perform the headlight auto leveling system initialization after newly replacing the AFS control module..
Exterior
...
Afs (Adaptive Front Lighting System) Off Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the AFS OFF switch..
3. Verify that the continuity between the AFS OFF switch terminals is as indicated
in the table.
If the cont ...
Other materials:
Replacing a Tire
WARNING
Always use tires that are in good condition:
Driving with worn tires is dangerous. Reduced braking, steering, and
traction could result
in an accident.
If a tire wears evenly, a wear indicator will appear as a solid band across
the tread.
Replace the tire when ...
Ventilator Grille Removal/Installation
Side Ventilator grille
1. Through the wiring harness into the position shown in the figure, remove the
side ventilator grille in the direction of arrow.
2. When installing the side ventilator grille, push it for the dashboard.
Center Ventilator grille
1. Disconnect the negative battery c ...
Washer Fluid Level Sensor Inspection
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Verify that continuity between the washer fluid-level sensor terminals is
as indicated in the table.
If not as specified, replace the washer fluid-level sensor.
...
