WARNING:
Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. When installing the fuel hose, perform “Fuel Leakage Inspection” described below.
A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before performing work on the fuel system, discharge static electricity by touching the vehicle body.
Fuel Leakage Inspection
Using M-MDS
1. Connect the M-MDS to the DLC-2.
2. Switch the ignition to ON.
3. Using the simulation function “FP”, start the fuel pump..
4. Verify that there is no fuel leakage from the pressurized parts.
There shall be no leakage after 5 min.
5. In the case of fuel leakage, replace the following components and then do the recheck by the fuel leakage checking procedure.
If there is leakage, replace the fuel hoses and clips.
If there is damage on the seal on the fuel pipe side, replace the fuel pipe.
Without using M-MDS
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the fuel pump relay.
CAUTION:
Short the specified terminals because shorting the wrong terminal of the relay and fuse block may cause malfunctions.
4. Using a jumper wire, short fuel pump relay terminals C and D in the relay and fuse block.
5. Connect the negative battery cable and operate the fuel pump..
6. Verify that there is no fuel leakage from the pressurized parts.
There shall be no leakage after 5 min.
7. In the case of fuel leakage, replace the following components and then do the recheck by the fuel leakage checking procedure.
If there is leakage, replace the fuel hoses and clips.
If there is damage on the seal on the fuel pipe side, replace the fuel pipe.
Receiving an Incoming Call
When an incoming call is received, the incoming call notification screen is
displayed. The
“Incoming Call Notifications” setting must be on.
Refer to Communication Settings on .
To accept the call, press the pick-up button on the audio control switch or
select on
the screen.
To rejec ...
Manual Transaxle Shift Pattern
The shift pattern of the transaxle is
conventional, as shown.
Depress the clutch pedal all the way down
while shifting; then release it slowly.
Your vehicle is equipped with a device to
prevent shifting to R (reverse) by mistake.
Push the shift lever downward and shift
to R.
...
Magnetic Clutch Inspection [Full Auto Air Conditioner]
1. Connect battery to terminal A of magnetic clutch and ground to A/C compressor
body.
SKYACTIV-G 2.0
MZR 2.3 DISI Turbo, MZR 2.5
2. Verify that the magnetic clutch operates.
If there is any malfunction, replace the magnetic clutch.
...