Mazda 3 Service Manual: Air Intake Actuator Inspection [Full Auto Air Conditioner]

Mazda 3 Service Manual / HVAC / A/C / Air Intake Actuator Inspection [Full Auto Air Conditioner]

1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table.

If the operation condition is not normal, replace the air intake actuator.


Terminal		Air intake actuator operation
B	C	Air intake actuator operation
B+	Ground	FRESH → RECIRCULATE
Ground	B+	RECIRCULATE → FRESH

A/C Unit Removal/Installation

1. Set the air mix mode to MAX COLD. 2. Disconnect the negative battery cable.. 3. Discharge the refrigerant.. 4. Drain the engine coolant.. 5. Remove the plug hole plate. 6. Remove the char ...

Air Intake Actuator Inspection [Manual Air Conditioner]

1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. ...

Other materials:

ABS HU/CM Removal/Installation
WARNING: If the ABS HU/CM configuration is not completed, it could result in an unexpected accident due to the ABS being inoperative. If the ABS HU/CM or ABS CM is replaced, always use the automatic configuration function so that the ABS operation conditions are correct. CAUTI ...

Schedule 2
U.S.A. (severe driving conditions) and Puerto Rico residents Chart symbols: I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary. R: Replace L : Lubricate T: Tighten Remarks: *1 Engine oil flexible maintenance is available for U.S.A. and Puerto Rico resi ...

Radiator Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...