Mazda 3 Service Manual: Air Intake Actuator Inspection [Manual Air Conditioner]

Air Intake Actuator Inspection [Full Auto Air Conditioner]

1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. ...

Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]

1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Front scuff plate (Passenger-side). b. Front side trim (Passenger-side). c. ...

Other materials:

Manual Transaxle Shift Mechanism Removal/Installation [G66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable. 3. Remove the battery component. (ex: battery, battery tray and PCM component). 4. Remove the air cleaner component.. 5. Remove the aerodynamic under cover NO.2.. 6. Remove the tunnel member (rear).. 7. Remove the u ...

Battery Inspection [Skyactiv G 2.0]
WARNING: Since battery acid is toxic, be careful when handling the battery. Since battery acid is highly corrosive, be careful not to allow it to contact clothing or the vehicle. In case battery acid contacts skin, eyes, or clothing, flush it immediately with running wa ...

Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate. b. Front side trim. c. Dashboard under cover. d. Upper panel. e. Shift lever knob (MTX). f. Selector lever knob (ATX). g. Shift panel. h. Side wall. i. Console. j. Hood release lever ...