Mazda 3 Service Manual: Air Mix Actuator Inspection [Full Auto Air Conditioner]
CAUTION:
-
If the lever position exceeds the operation range shown in the figure, the circuit in the actuator could be damaged. Always perform an actuator operation inspection with the lever movement within the range shown in the figure.
Driver-side
1. Connect battery positive voltage to air mix actuator terminal C (or B), connect terminal B (or C) to ground, and then verify that the air mix actuator operates as shown in the table.
-
If the operation condition is not normal, replace the air mix actuator.
|
Terminal |
Air mix actuator operation |
|
|
B |
C |
|
|
B+ |
Ground |
COLD → HOT |
|
Ground |
B+ |
HOT → COLD |
2. Verify that the resistance between terminals F and G, E and F matches the air mix actuator operation as shown in the graph.
-
If the operation condition and resistance are not normal, replace the air mix actuator.
Passenger-side
1. Connect battery positive voltage to air mix actuator terminal C (or B), connect terminal B (or C) to ground, and then verify that the air mix actuator operates as shown in the table.
-
If the operation condition is not normal, replace the air mix actuator.
|
Terminal |
Air mix actuator operation |
|
|
B |
C |
|
|
B+ |
Ground |
HOT → COLD |
|
Ground |
B+ |
COLD → HOT |
2. Verify that the resistance between terminals F and G, E and F matches the air mix actuator operation as shown in the graph.
-
If the operation condition and resistance are not normal, replace the air mix actuator.
Air Intake Actuator Removal/Installation [Manual Air Conditioner]
1. Set the air intake mode to FRESH.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Front scuff plate (Passenger-side).
b. Front side trim (Passenger-side).
c. ...
Air Mix Actuator Removal/Installation [Full Auto Air Conditioner]
Driver-side
1. Disconnect the negative battery cable..
2. Disconnect the connector.
3. Remove the hook (1), remove the rod (2) from the air mix actuator link.
4. Remove the screw.
5. ...
Other materials:
Air Filter Inspection [Mzr 2.0, Mzr 2.5]
Except for Mexico
Airflow inspection
1. Remove the air filter..
2. Blow from port A and verify that there is airflow from port B.
If there is no airflow, replace the air filter..
3. Blow from port B and verify that there is airflow from port A.
If there is no airflow, r ...
Front Door Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Remove the front door speaker..
5. Verify the resistance between the front door speaker terminals.
If not within the specification, replace the front door speaker.
...
Wheel Hub Component Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor connector (axle side) ...
