Mazda 3 Service Manual: Antenna Feeder No.6 Removal/Installation

Antenna Feeder No.6 Inspection

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper panel. b. Shift knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Console. g ...

Antenna Feeder No.7 Inspection

1. Disconnect the negative battery cable.. 2. Remove the liftgate upper trim.. 3. Disconnect the connector A and B.. 4. Verify that the continuity between antenna feeder No.7 terminals is as ind ...

Other materials:

Seat Weight Sensor Control Module Removal/Installation [Two Step Deployment Control System]
CAUTION: When the seat weight sensor control module is replaced with a new one, perform the seat weight sensor calibration using the M–MDS.. 1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Disconnect the connectors. ...

Front Fog Light Aiming
CAUTION: If the front fog light aiming is adjusted with cargo in the vehicle, it may not adjust correctly. Adjust the front fog light aiming with the vehicle under the following conditions: No occupants inside vehicle Cargo other than spare tire, jack, and tools ...

Compression Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Hot engines and oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component. Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel ...