Assist Handle Removal
1. Insert a flathead screwdriver into the service hole and remove the assist handle covers.
2. Remove the assist handle in the direction of the arrow (1) and (2), while detach the clip.
NOTE:
Remove the assist handle by shaking it up and down.
Assist Handle Installation
1. Push the assist handle in the direction of the arrow shown in the figure.
2. Push the assist handle cover assembled to install the assist handle.
Caliper (Rear) Disassembly/Assembly
1. Disassemble in the order indicated in the table.
1
Dust seal
(See Dust Seal Assembly Note.)
2
Bleeder cap
3
Bleeder screw
4
Caliper body
2. Assemble in the reverse orde ...
Oil Pressure Switch Inspection
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before removing the exhaust system.
1. Disconnect the negative battery cable..
2. Remove the aerodynamic under cover No.2..
3. Remove the oil pressur ...
Buckle Switch Inspection
Driver Side
1. Switch the ignition to off.
2. Disconnect the negative battery cable..
3. Remove the front seat..
4. Remove the front buckle..
5. Inspect for continuity between the buckle switch terminals using a tester.
If not as indicated in the table, replace the driver sid ...