Mazda 3 Service Manual: Audio Unit Removal/Installation
Without Display
CAUTION:
-
When installing the audio unit, make sure that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the wiring harness or the antenna feeder is caught between the unit and dashboard, it may cause malfunctions.
-
Pressing the switch area of the audio unit when installing it could result in a malfunction. Therefore only press the hatched area shown in the figure.
1. Disconnect the negative battery cable..
2. Remove the center panel..
3. Remove in the order indicated in the table.
|
1 |
Screw |
|
2 |
Clip |
|
3 |
Connector |
|
4 |
Audio unit |
4. Install in the reverse order of removal.
With Display
CAUTION:
-
When installing the audio unit, make sure that the wiring harness and antenna feeder are not caught between the unit and dashboard. If the wiring harness or the antenna feeder is caught between the unit and dashboard, it may cause malfunctions.
-
Pressing the switch area of the audio unit when installing it could result in a malfunction. Therefore only press the hatched area shown in the figure.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. center panel.
b. Passenger-side front scuff plate.
c. Passenger-side front side trim.
d. Dashboard under cover.
e. Glove compartment.
f. Passenger-side lower panel.
3. Remove the screws.
4. Remove in the order indicated in the table.
|
1 |
Screw |
|
2 |
Clip |
|
3 |
Connector |
|
4 |
Audio unit |
5. Remove the bolt.
6. Remove the bracket.
7. Install in the reverse order of removal.
Audio Unit Disassembly/Assembly
CAUTION:
When disassembling the audio unit, it could get scratched if it is placed
directly on the ground. When disassembling the audio unit, spread a soft cloth
underneath to perform th ...
Auxiliary Jack Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Upper panel.
b. Shift lever knob (MTX).
c. Selector lever knob (ATX).
d. Shift panel.
e. Side wall.
f. Consol ...
Other materials:
Fuel Tank Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin and eyes. To prevent this, always complete the “Fuel
Line Safety Procedure”, while referring to ...
Afs (Adaptive Front Lighting System) Control Module Removal/Installation
NOTE:
Perform the auto leveling system initialization after newly replacing the
AFS control module to assure that the auto leveling system operates correctly.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Passenger-side front scuff plate.
b. Pass ...
Front Door Trim Disassembly/Assembly
Driver-side
1. Disassemble in the order shown in the figure.
1
Screw A
2
Assist handle
3
Switch panel cover
4
Screw B
5
Power window main switch
...
