Mazda 3 Service Manual: Auto Dimming Mirror Inspection

Mazda 3 Service Manual / Body / Mirrors / Auto Dimming Mirror Inspection

1. Measure the voltage at each terminal.

If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under “Inspection item (s)” and related wiring harnesses.

If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the auto-dimming mirror.

Terminal Voltage Table (Reference)


Terminal	Signal name	Connected to	Measured condition	Voltage (V)	Inspection item(s)
A	Power supply (IG1)	Ignition switch METER 15 A fuse	Switch the ignition to ON	B+	Ignition switch METER 15 A fuse Related wiring harnesses
A	Power supply (IG1)	Ignition switch METER 15 A fuse	Switch the ignition to Off	1.0 or less	Ignition switch METER 15 A fuse Related wiring harnesses
B	R position signal	Back-up light switch/TR switch	R position	B+	Back-up light switch/TR switch Related wiring harnesses
B	R position signal	Back-up light switch/TR switch	Other than R position	1.0 or less	Back-up light switch/TR switch Related wiring harnesses
D	GND	Body ground	Under any condition	1.0 or less	Related wiring harnesses

Mirrors

...

Auto Dimming Mirror Installation

1. Install the auto-dimming mirror onto the base. 2. Install the screw. 3. Connect the auto-dimming mirror connector. 4. Connect the negative battery cable.. ...

Other materials:

Operating the Driver's Power Window
Normal opening/closing To open the window to the desired position, lightly hold down the switch. To close the window to the desired position, lightly pull up the switch. Auto-opening/closing To fully open the window automatically, press the switch completely down, then release. The win ...

Control System Personalization Features Setting Procedure
1. Connect the M-MDS to the DLC-2. 2. After the vehicle is identified, select the following items from the initial screen of the M-MDS. When using the IDS (laptop PC) Select the “Module Programming”. Select the “Programmable Parameters”. 3. Select ...

Electric Power Steering Oil Pump Component Removal/Installation
CAUTION: Be careful not to drop the electric power steering oil pump component as the internal parts of the EHPAS CM could be damaged. Replace the electric power steering oil pump component if it is subjected to an impact. 1. Remove the front mudguard (RH).. 2. Remove the aerod ...