Mazda 3 Service Manual: Automatic
- Automatic Transaxle Fluid (ATF) Adjustment [Fw6 A EL]
- Automatic Transaxle Fluid (ATF) Inspection [FS5 A EL]
- Automatic Transaxle Fluid (ATF) Inspection [Fw6 A EL]
- Automatic Transaxle Fluid (ATF) Replacement [FS5 A EL]
- Automatic Transaxle Fluid (ATF) Replacement [Fw6 A EL]
- Automatic Transaxle Removal/Installation [FS5 A EL]
- Automatic Transaxle Removal/Installation [Fw6 A EL]
- Automatic Transaxle Shift Mechanism Removal/Installation
- Basic Inspection [FS5 A EL]
- Control Valve Body Removal/Installation [FS5 A EL]
- Control Valve Body Removal/Installation [Fw6 A EL]
- Coupler Component Removal/Installation [Fw6 A EL]
- Down Switch Inspection [FS5 A EL]
- Down Switch Inspection [Fw6 A EL]
- Drive Plate Removal/Installation [FS5 A EL]
- Drive Plate Removal/Installation [Fw6 A EL]
- Electric Power Steering Oil Pump Component Disassembly/Assembly
- Electric Power Steering Oil Pump Component Removal/Installation
- Initial Learning [Fw6 A EL]
- Intermediate Sensor Inspection [FS5 A EL]
- Intermediate Sensor Removal/Installation [FS5 A EL]
- Joint Shaft Assembly [Mzr 2.5 (ATX)]
- Judder Upon Torque Converter Clutch (TCC) Operation [Fw6 A EL]
- Key Interlock System Inspection
- M Position Switch Inspection [FS5 A EL]
- M Position Switch Inspection [Fw6 A EL]
- Neutral Switch Removal/Installation [A26 M R]
- Neutral Switch Removal/Installation [C66 M R]
- Neutral Switch Removal/Installation [G35 M R]
- Neutral Switch Removal/Installation [G66 M R]
- No.12 Torque Converter Clutch (TCC) Non Operation [FS5 A EL]
- No.16 Judder Upon Torque Converter Clutch (TCC) Operation [FS5 A EL]
- Oil Pump Removal/Installation [Mzr 2.0, Mzr 2.5]
- Oil Pump Removal/Installation [Mzr 2.3 Disi Turbo]
- Oil Pump Removal/Installation [Skyactiv G 2.0]
- Oil Seal (Control Valve Body) Replacement [Fw6 A EL]
- On/Off Solenoid Removal/Installation [Fw6 A EL]
- Pilot Bearing Inspection [A26 M R]
- Pilot Bearing Inspection [C66 M R]
- Pilot Bearing Inspection [G35 M R]
- Pilot Bearing Inspection [G66 M R]
- Selector Lever Inspection
- Shift Lock System Inspection
- Solenoid Valve Inspection [FS5 A EL]
- Solenoid Valve Removal/Installation [FS5 A EL]
- Starter Interlock Switch Inspection [Mzr 2.0, Mzr 2.5]
- Starter Interlock Switch Inspection [Mzr 2.3 Disi Turbo]
- Starter Interlock Switch Inspection [Skyactiv G 2.0]
- Starter Interlock Switch Removal/Installation [C66 M R]
- TCM Configuration [Fw6 A EL]
- TCM Inspection [FS5 A EL]
- TCM Removal/Installation [FS5 A EL]
- Torque Converter Clutch (TCC) Non Operation [Fw6 A EL]
- Transmission/Transaxle SST
- Up Switch Inspection [FS5 A EL]
- Up Switch Inspection [Fw6 A EL]
Transaxle Range (TR) Switch Removal/Installation [FS5 A EL]
CAUTION:
Water or foreign objects entering the connector can cause a poor connection
or corrosion. Be sure not to drop water or foreign objects on the connector
when disconnecting it.
...
Automatic Transaxle Fluid (ATF) Adjustment [Fw6 A EL]
CAUTION:
Only adjust the ATF level when the ATF temperature is 45—55 °C {113—131 °F}.
If the ATF level is incorrect, it could damage the transaxle.
Do not add ATF over the specifica ...
Other materials:
Identification Number Locations
Vehicle Identification Number (VIN)
Engine Type/Number
MZR 2.0, MZR 2.5
MZR 2.3 DISI Turbo
SKYACTIV-G 2.0
...
Shroud Panel Removal/Installation
CAUTION:
Because the shroud panel is installed to the bumper reinforcement, support
the shroud panel using a jack before removing the bumper reinforcement so as
not to apply excessive force to the shroud panel.
Since the servicing is performed with the hood open, secure the hoo ...
Windshield Washer Nozzle Removal/Installation
1. Remove the following parts:
a. Windshield wiper arm and blade.
b. Front fender molding.
c. Cowl grille.
2. Remove the windshield washer hose from the windshield washer nozzle.
3. Squeeze the tabs of the windshield washer nozzle.
4. Pull the windshield washer nozzle out to remove it.
...
