CAUTION:
If the ATF level is not within the specification or ATF is not adhering to the dipstick after warming up the engine, do not drive the vehicle. Otherwise, the transaxle could be damaged.
ATF Level Inspection
1. Remove aerodynamic undercover No.2..
2. Remove the dipstick securing bolt.
3. Connect the M-MDS to the DLC-2 and display the PID TFT.
4. Warm up the engine until the ATF temperature is 50 °C {122 °F}
.
5. Remove the dipstick and wipe ATF off using a nylon cloth while leaving the engine idling.
6. Insert the dipstick and pull it out again.
7. Verify that the ATF is adhering between L and F on the dipstick.
If ATF is not adhering between L and F on the dipstick, adjust the ATF level..
Genuine ATF FZ
8. Insert the dipstick and install the securing bolt.
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}
9. Install aerodynamic undercover No.2..
Brake Switch Inspection
CAUTION:
Inspect the brake switch with it installed to the brake pedal, otherwise
the brake switch may not operate normally. If the brake switch is removed from
the brake pedal, replace the brake switch with a new one.
1. Disconnect the brake switch connector.
2. Verify that th ...
Rear Door Child Safety Locks
These locks are intended to help prevent
children from accidentally opening the
rear doors. Use them on both rear doors
whenever a child rides in the rear seat of
the vehicle.
If you slide the child safety lock to the
lock position before closing that door, the
door cannot be opened from th ...
Automatic Transaxle Fluid (ATF) Adjustment [Fw6 A EL]
CAUTION:
Only adjust the ATF level when the ATF temperature is 45—55 °C {113—131 °F}.
If the ATF level is incorrect, it could damage the transaxle.
Do not add ATF over the specification. Otherwise, the transaxle performance
could be reduced and ATF could leak.
1. Remove a ...