WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before changing the ATF.
1. Drain the ATF.
a. Remove the oil dipstick.
b. Remove the aerodynamic under cover NO.2..
c. Remove the drain plug and washer to drain the ATF into a container.
2. Add the ATF.
a. Install a new washer and the drain plug.
30—41 N·m {3.1—4.1 kgf·m, 23—30 ft·lbf}
b. Add the specified ATF through the oil filler tube.
Mazda Genuine ATF M-V
Draining ATF from drain plug: 3.0 L {3.2 US qt, 2.6 lmp qt}
Overhauling transaxle: 5.0 L {5.3 US qt, 4.4 lmp qt}
3. Install the aerodynamic under cover NO.2..
4. Install the oil dipstick.
5. Inspect the ATF level..
Master Cylinder Removal/Installation [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove the battery and battery tray..
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
1
Brake fluid level sensor connector
2
Reserve hose (MTX)
(See Reserve Hose (MTX) Removal Note.)
(Se ...
Rear Door Pad Removal/Installation
1. Fully open the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Rear door trim.
b. Rear door speaker.
c. Rear power window motor.
d. Rear door quarter glass.
e. Rear door glass.
f. Rear door module panel.
4. Remove the service hole co ...
Spark Plug Inspection [Mzr 2.3 Disi Turbo]
Specification
Spark plug type
L3BD-18110, L3YD-18110
Plug Gap Inspection
CAUTION:
To avoid possible damage to the tip, do not adjust the plug gap.
To prevent damaging the tip, use a wire type plug gap gauge when inspecting
the plug gap.
1. Measure the spark p ...