Mazda 3 Service Manual: Automatic Transmission Control

Up Switch Inspection [Fw6 A EL]

Continuity Inspection NOTE: The up switch is built into the selector lever component. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the console. ...

Boost Air Temperature Sensor Inspection [Mzr 2.3 Disi Turbo]

Resistance Inspection NOTE: Because the boost air temperature sensor is integrated in the MAP sensor, replacing the boost air temperature sensor includes replacement of the MAP sensor/boos ...

Other materials:

Neutral Switch Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover No.2.. 4. Install in the reverse order of removal. 5. Remove in the order indicated in the table. 6. Install in the reverse order of removal. 1 Neutr ...

Generator Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Remove and install all parts when the engine is cold, otherwise they can cause severe burns or serious injury. When the battery cables are connected, touching the vehicle body with generator terminal B will generate sparks. This can cause personal injury, fire, and ...

Removing a Flat Tire
If your vehicle is equipped with a wheel cover, pry off the wheel cover with the beveled end of the jack lever. NOTE Force the end of the jack lever firmly between wheel and cover, or removal will be difficult. CAUTION Align the notch on the wheel cover with the valve ...