Mazda 3 manuals

Mazda 3 Service Manual: Base Installation

1. Cut away all of the original sealant using a razor.

WARNING:

2. Clean and degrease the ceramic coating on the glass and the base.

CAUTION:

3. Apply primer to the bonding area of the glass and the base.

4. Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for approx. 30 min.

5. Apply 3.0 mm {0.12 in}

layer of sealant to the base.


6. Center the base in the ceramic coating and press it onto the glass.


7. Use isopropyl alcohol to remove any excess repair sealant. Hardening time of sealant


Temperature

Surface hardening time

Time required until car can be put into service

5 °C {41 °F}

Approx. 1.5 h

Approx. 12 h

20 °C {68 °F}

Approx. 1 h

Approx. 4 h

35 °C {95 °F}

Approx. 10 min

Approx. 2 h


8. Install the rearview mirror.

9. Connect the negative battery cable..

Glass & Windows
...

Base Removal
1. Remove the rearview mirror.. 2. Wind each end of a wire around a bar. WARNING: Using the piano wire with bare hands can cause injury. Always wear gloves when using the piano wire ...

Other materials:

Variable Valve Timing Actuator Removal/Installation [Mzr 2.3 Disi Turbo]
WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin ...

Quick Release Connector (Emission System) Removal/Installation [Mzr 2.0, Mzr 2.5]
Quick Release Connector Type CAUTION: Verify the type and location, and install/remove properly. Except for Mexico Mexico Type A Removal CAUTION: Be careful not to damage the evaporative pipe when unlocking the retainer. NOTE: When removing the quick r ...

Tachometer
The tachometer shows engine speed in thousands of revolutions per minute (rpm). CAUTION Do not run the engine with the tachometer needle in the RED ZONE. This may cause severe engine damage. Type A *1 The range varies depending on the type of gauge. Type B *1 The ...

© 2016-2024 Copyright www.mazda3tech.com