Mazda 3 Service Manual: Base Installation
1. Cut away all of the original sealant using a razor.
WARNING:
-
Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
2. Clean and degrease the ceramic coating on the glass and the base.
CAUTION:
-
Keep the area free of dirt and grease, and do not touch the surface. Otherwise, the primer may not properly bond to the surface of the glass.
3. Apply primer to the bonding area of the glass and the base.
4. Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for approx. 30 min.
5. Apply 3.0 mm {0.12 in}
layer of sealant to the base.
6. Center the base in the ceramic coating and press it onto the glass.
7. Use isopropyl alcohol to remove any excess repair sealant. Hardening time of sealant
|
Temperature |
Surface hardening time |
Time required until car can be put into service |
|
5 °C {41 °F} |
Approx. 1.5 h |
Approx. 12 h |
|
20 °C {68 °F} |
Approx. 1 h |
Approx. 4 h |
|
35 °C {95 °F} |
Approx. 10 min |
Approx. 2 h |
8. Install the rearview mirror.
9. Connect the negative battery cable..
Auto Dimming Mirror Removal
1. Disconnect the negative battery cable.
2. Remove the screw.
3. Disconnect the auto-dimming mirror connector.
4. Pull out the rearview mirror toward the vehicle rear.
CAUTION:
...
Base Removal
1. Remove the rearview mirror..
2. Wind each end of a wire around a bar.
WARNING:
Using the piano wire with bare hands can cause injury. Always wear gloves
when using the piano wire ...
Other materials:
Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the under cover..
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
1
Connector
2
Bolt
3
Rear ABS wheel-speed sensor
4
ABS hole cov ...
Accessory Sockets
Only use genuine Mazdaaccessories or the
equivalent requiring no greater than 120 W
(DC 12 V, 10 A).
Type A
The accessory sockets can be used
regardless of whether the ignition is on or
off.
Type B *
The ignition must be switched to ACC or
ON.
With CD Player
Without CD Player
...
Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure
plate and A/C compressor pulley using a thickness gauge.
2. Verify that the clearance.
If not within the specification, remove the pressure plate and adjust the
clearance by changing the shim (0.2 mm {0. ...
