Mazda 3 manuals

Mazda 3 Service Manual: Before Service Precaution [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Fuel / Before Service Precaution [Mzr 2.0, Mzr 2.5]

WARNING:

Fuel Line Safety Procedure

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the fuel-filler cap to release the pressure inside the fuel tank.

4. Remove the fuel pump relay.


5. Connect the negative battery cable..

6. Start the engine.

7. After the engine stalls, crank the engine 2—3 times.

8. Switch the ignition to off.

9. Disconnect the negative battery cable..

10. Install the fuel pump relay.

After Service Precaution [Mzr 2.0, Mzr 2.5]
WARNING: Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. When installing the fuel hose, perform “Fuel Leakage Inspection” desc ...

Fuel Filler Cap Inspection [Mzr 2.0, Mzr 2.5]
Leakage Inspection 1. Perform the following SST (Evaporative Emission System Tester 134-01049A) self-test: NOTE: If the tester does not work correctly during self-test, refer to the teste ...

Other materials:

Glass Panel Adjustment
1. Fully close the glass panel. 2. Measure the gap and height between the glass panel and body. If not as specified, loosen the glass panel installation screws and reposition the glass panel. Clearance (4SD) a: -2.4—0.2 mm {-0.09—0.01 in} b: 0 mm {0 in} ...

Owner Maintenance Precautions
The owner or a qualified service technician should make these vehicle inspections at the indicated intervals to ensure safe and dependable operation. Bring any problem to the attention of an Authorized Mazda Dealer or qualified service technician as soon as possible. When Refueling Bra ...

Body And Accessories
ABBREVIATIONS ACC Accessories AUX Auxiliary jack CAN Controller Area Network DLC Data Link Connector GND Ground LH Left Hand ...

© 2016-2024 Copyright www.mazda3tech.com