Mazda 3 Service Manual: Boost Air Temperature Sensor Inspection [Mzr 2.3 Disi Turbo]

Ambient Temperature Sensor Removal/Installation [Manual Air Conditioner]

1. Disconnect the negative battery cable.. 2. Remove the aerodynamic under cover No.2.. 3. Remove the aerodynamic under cover No.1.. 4. Disconnect the connector. 5. Remove the ambient temp ...

Manifold Absolute Pressure (Map) Sensor/Boost Air Temperature Sensor Removal/Installation [Mzr 2.3 Disi Turbo]

NOTE: Because the boost air temperature sensor is integrated in the MAP sensor, replacing the boost air temperature sensor includes replacement of the MAP sensor/boost air temperature se ...

Other materials:

Key Removed from Vehicle Warning Beep
Vehicles with advanced keyless function If the key is taken out of the vehicle while the ignition is not switched OFF and all the doors are closed, the beep which sounds outside of the vehicle will be heard 6 times, the beep which sounds inside the vehicle will be heard 6 times, and the KEY w ...

Oil Seal (Differential) Replacement [G35 M R]
1. On level ground, jack up the vehicle and support it evenly on safety stands. 2. Remove the aerodynamic under cover No.2.. 3. Drain the oil from the transaxle.. 4. Remove the front splash shield.. 5. Separate the drive shaft and joint shaft from the transaxle.. 6. Remove the oil seals u ...

Maintenance of the Active Driving Display
The combiner and mirror surface have a special coating. When cleaning, do not use a hard or rough-surface cloth, or cleaning detergent. In addition, if a chemical solvent gets on the active driving display, wipe it off immediately. Otherwise, the combiner and mirror could be damaged and the s ...