Mazda 3 Service Manual: Brakes

Rain Sensor Removal/Installation

1. Disconnect the negative battery cable.. 2. Spread open the rain sensor cover in the direction of the arrows and disengage tabs A to remove it. 3. Disconnect the rain sensor connector. ...

General

...

Other materials:

Solenoid Valve Removal/Installation [FS5 A EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Primary Control Valve Body 1. Remove the primary control valve body. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the aerodynamic un ...

Key Removed from Vehicle Warning Beep
Vehicles with advanced keyless function If the key is taken out of the vehicle while the ignition is not switched OFF and all the doors are closed, the beep which sounds outside of the vehicle will be heard 6 times, the beep which sounds inside the vehicle will be heard 6 times, and the KEY w ...

Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off. 2. Install the SSTs to the master cylinder (secondary side) as shown in the figure. NOTE: When installing the SST (49 D043 0A0) to the master cylinder, use a commercially available flare nut wrench (flare nut across flat 12 mm {0.47 in}). ...