Mazda 3 manuals

Mazda 3 Owners Manual: BSM OFF Indicator Light

Mazda 3. BSM OFF Indicator Light


This indicator light illuminates for a few seconds when the ignition is switched ON.

The BSM OFF indicator light illuminates when the BSM system is turned off by pressing the BSM OFF switch.

The indicator light flashes if the BSM system has a malfunction. Consult an Authorized Mazda Dealer.

NOTE If the vehicle is driven on a road with less traffic and few vehicles that the radar sensors can detect, the system may pause (The BSM OFF indicator light in the instrument cluster flashes). However, it does not indicate a malfunction.

Blind Spot Monitoring (BSM) Warning Lights/Blind Spot Monitoring (BSM) Warning Beep
The Blind Spot Monitoring (BSM) or Rear Cross Traffic Alert (RCTA) system notifies the driver of the presence of vehicles in adjacent lanes to the rear of your vehicle using the Blind Spot Monit ...

BSM OFF Switch
When the BSM OFF switch is pressed, the Blind Spot Monitoring (BSM) and Rear Cross Traffic Alert (RCTA) systems are turned off and the BSM OFF Indicator Light in the instrument cluster turns o ...

Other materials:

Saving Fuel and Protection of the Environment
How you operate your Mazda determines how far it will travel on a tank of fuel. Use these suggestions to help save fuel and reduce CO2. Avoid long warm-ups. Once the engine runs smoothly, begin driving. Avoid fast starts. Drive at lower speeds. Anticipate when to apply the brakes (a ...

Oil Seal (Differential) Replacement [Fw6 A EL]
1. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 2. Remove the oil seal. a. Drain the ATF.. b. Disconnect the drive shaft (LH) from the transaxle.. c. Disconnect the drive shaft (RH) from the joint shaft.. d. Remove the joint shaft.. CAUTION: ...

Starter Interlock Switch Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the starter interlock switch connector. 4. Remove the starter interlock switch from the pedal bracket. 5. Insert a new starter interlock switch into the pedal bracket hole in the direction indicated ...

© 2016-2024 Copyright www.mazda3tech.com