Mazda 3 Service Manual: Camshaft Position (CMP) Sensor Inspection [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Engine Assembly / Valvetrain, Cylinder Head / Camshaft Position (CMP) Sensor Inspection [Mzr 2.0, Mzr 2.5]

Visual Inspection

CAUTION:

When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the plug hole plate..

4. Disconnect the CMP sensor connector.

5. Remove the CMP sensor..

6. Verify that there are no metal shavings on the CMP sensor.

Remove any metal shavings that are adhering.

Voltage Inspection

CAUTION:

When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
If the wiring harnesses or waterproof connectors are damaged, water penetrating the connector will cause a sensor malfunction. To prevent this, be careful not to damage wiring harnesses or waterproof connectors.

1. Idle the engine.

2. Measure the CMP signal and verify that rectangular waves are produced..

If not as specified, replace the CMP sensor..

Valvetrain, Cylinder Head

...

Camshaft Position (CMP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]

CAUTION: When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfu ...

Other materials:

Clutch Disc Inspection [C66 M R]
Operation Inspection 1. Inspect the lining surface for discoloration and grease adhesion. 2. Inspect the torsion spring for weakness and the rivet for looseness. 3. Using a vernier caliper, measure the depth between the lining surface and the rivet head. Minimum clutch disc thickness ...

Operational Range
The system operates only when the driver is in the vehicle or within operational range while the key is being carried. Starting the Engine NOTE Starting the engine may be possible even if the key is outside of the vehicle and extremely close to a door and window, however, always start ...

M Position Switch Inspection [FS5 A EL]
1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the console.. d. Disconnect the selector lever component connector. 2. Inspect the continuity between the selector lever component terminals A and H. If ...