Mazda 3 manuals

Mazda 3 Service Manual: Check Valve (One Way) Inspection [Mzr 2.3 Disi Turbo]

Mazda 3 Service Manual / Engine / Emissions / Check Valve (One Way) Inspection [Mzr 2.3 Disi Turbo]

1. Disconnect the vacuum hose connected between the check valve and the purge solenoid valve from the purge solenoid valve..

2. Disconnect the vacuum hose connected between the check valve (one-way) and the intake manifold from the intake manifold..

3. Blow through the check valve (one-way) and verify that air flows as specified.


Specification


Condition

Airflow

Air applied from port A to B

Yes

Air applied from port B to A

No*


* The check valve (one-way) is normal if the aeration to port A is 3.5 kPa/min {0.03 kgf/cm2 min, 0.5 psi/min} or less

when 130 kPa {1.32 kgf/cm2, 18.9 psi}

is applied to port B.

Charcoal Canister Removal/Installation [Mzr 2.0, Mzr 2.5]
Except for Mexico 1. Remove in the order indicated in the table. 1 Evaporative hose 2 Quick release connector (See QUICK RELEASE CONNECTOR ...

Check Valve (Two Way) Removal/Installation [Mzr 2.0, Mzr 2.5]
Mexico NOTE: The check valve (two-way) cannot be removed as it is built into the rollover valve. The rollover valve cannot be removed as it is built into the fuel tank. 1. Re ...

Other materials:

Rear Door Latch And Lock Actuator Removal/Installation
1. Fully open the rear door glass. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Rear door trim. b. Rear inner handle. c. Rear door speaker. d. Rear power window motor. e. Rear door glass. 4. Remove the screw. 5. Remove the rear door latch and loc ...

PID/Data Monitor Inspection [Bcm]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “BCM/GEM”. 3. Select the applicable PID from the PID table. 4. Verify the PID da ...

Rearview Mirror Removal
1. Insert a tape-wrapped flathead screwdriver to the position shown in the figure and press the center part of the spring in the direction of arrows (1), and then pull out the rearview mirror in the direction of arrows (2) shown in the figure. CAUTION: When removing the rearview m ...

© 2016-2024 Copyright www.mazda3tech.com