Operation Inspection
1. Inspect the lining surface for discoloration and grease adhesion.
2. Inspect the torsion spring for weakness and the rivet for looseness.
3. Using a vernier caliper, measure the depth between the lining surface and the rivet head.
0.3 mm {0.01 in}
If it is less than the minimum specification, replace the clutch disc..
4. Measure the clutch disc runout using a dial gauge.
0.7 mm {0.03 in}
If it exceeds the maximum specification, replace the clutch disc..
Outer Mirror Garnish Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the outer mirror glass from the outer mirror..
3. Pinch the end of the tab which is visible, and release the tab by pressing
it toward the vehicle front (3 locations).
4. Grasp the upper side of the outer mirror garnish and remove it b ...
Rear Door Latch And Lock Actuator Removal/Installation
1. Fully open the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Rear door trim.
b. Rear inner handle.
c. Rear door speaker.
d. Rear power window motor.
e. Rear door glass.
4. Remove the screw.
5. Remove the rear door latch and loc ...
Customer Assistance (Canada)
Satisfaction Review Process
Your complete and permanent satisfaction is of primary concern to Mazda. All
Authorized
Mazda Dealers have both the knowledge and tools to keep your Mazda in top
condition.
In our experience, any questions, problems, or complaints regarding the
operation of you ...