Mazda 3 manuals

Mazda 3 Service Manual: Controller Area Network (Can) System

Mazda 3 Service Manual / Electrical / Data Network / Controller Area Network (Can) System

Outline

System Wiring Diagram


CAN Signal Table

MS-CAN

OUT: Output (sends signal)IN: Input (receives signal)

Signal

Multiplex module

AUDIO UNIT

MULTI INFORMATION DISPLAY/INFORMATION DISPLAY

USB ADAPTER

Text data

IN

OUT

Playback information

IN

OUT

OUT

IN

Operation signal

OUT

IN

USB device state

IN

OUT


Body Control Module (Bcm) Removal/Installation
CAUTION: When replacing the BCM, the configuration procedure must be performed before removing the BCM. Replacing the BCM without performing the configuration procedure will result in sy ...

On Board Diagnostic System PID/Data Monitor Inspection [FS5 A EL]
NOTE: The PID data screen function is used for monitoring the calculated value of input/output signals in the module. Therefore, if the monitored value of the output parts is not within ...

Other materials:

Windshield Removal
1. Disconnect the negative battery cable. 2. Remove the following parts: a. Windshield wiper arm and blade. b. Cowl grille. c. Rain sensor (Vehicles with auto light/wiper system). d. Auto-dimming mirror (Vehicles with auto-dimming mirror). e. Rear view mirror (Vehicles without auto-dimmi ...

Heater Core Inspection
1. Inspect the heater core for damage, cracks, and water leakage. If there is any malfunction, replace the heater core. 2. Visually inspect the fins for bending. If there is any bending, use the end of a flathead screwdriver to straighten the fins. 3. Visually inspect ...

Transaxle Range (TR) Switch Removal/Installation [FS5 A EL]
CAUTION: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it. 1. Engage the parking brake and use wheel chocks at the front and rear of the wheels. 2. Shi ...

© 2016-2024 Copyright www.mazda3tech.com