Mazda 3 Service Manual: Cooling
- Coolant Reserve Tank Removal/Installation [Mzr 2.0, Mzr 2.5]
- Cooling Fan Component Removal/Installation [Mzr 2.0, Mzr 2.5]
- Cooling System Cap Inspection [Mzr 2.0, Mzr 2.5]
- Cooling System Service Warnings [Mzr 2.0, Mzr 2.5]
- Engine Coolant Leakage Inspection [Mzr 2.0, Mzr 2.5]
- Engine Coolant Level Inspection [Mzr 2.0, Mzr 2.5]
- Engine Coolant Protection Inspection [Mzr 2.0, Mzr 2.5]
- Engine Coolant Replacement [Mzr 2.0, Mzr 2.5]
- Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Engine Coolant Temperature (ECT) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Fan Switch Inspection [Manual Air Conditioner]
- Fuel Gauge Sender Unit Inspection
- Fuel Gauge Sender Unit Removal/Installation
- Radiator Drain Plug Replacement [Mzr 2.0, Mzr 2.5]
- Radiator Removal/Installation [Mzr 2.0, Mzr 2.5]
- Shroud Panel Removal/Installation
- Water Pump Removal/Installation [Mzr 2.0, Mzr 2.5]
- Thermostat Inspection [Mzr 2.0, Mzr 2.5]
- Thermostat Removal/Installation [Mzr 2.0, Mzr 2.5]
CAUTION:
If foreign materials are stuck to the sensor, disturbance by magnetic flux
can cause sensor output to be abnormal and thereby negatively affect control.
Make sure that foreign m ...
WARNING:
Never remove the cooling system cap or loosen the radiator drain plug while
the engine is running, or when the engine and radiator are hot. Scalding engine
coolant and steam may ...
Other materials:
Drive Belt Inspection [Skyactiv G 2.0]
Generator Drive Belt
NOTE:
The generator drive belt deflection/tension inspection is not necessary with
the adoption of the drive belt auto tensioner.
1. Verify that the indicator part of the cast hexagon on the drive belt auto
tensioner is within the normal range.
If ...
Customer Assistance (Mexico)
Your complete and permanent satisfaction is our business. We are here to
serve you. All
Authorized Mazda Dealers have the knowledge and the tools to keep your Mazda
vehicle in
top condition.
If you have any questions or recommendations for improvement regarding the
service of
your Mazda ...
Inner Garnish Removal/Installation
1. Disconnect the negative battery cable..
2. Pull the inner garnish in the direction of the arrow shown in the figure and
remove it while detaching clips and tab.
CAUTION:
When pulling out the inner garnish, be careful not to damage the tab.
3. Disconnect the front tweeter c ...