Mazda 3 Owners Manual: Cooling (With air conditioner)
- Set the mode selector dial to the
position. - Set the temperature control dial to the cold position.
- Set the fan control dial to the desired speed.
- Turn on the air conditioner by pressing the A/C switch.
- After cooling begins, adjust the fan control dial and temperature control dial as needed to maintain maximum comfort.
| CAUTION
If the air conditioner is used while driving up long hills or in heavy
traffi c, monitor the engine coolant temperature warning light to see if
it is illuminated or fl ashing . The air conditioner may cause engine overheating. If the warning light is illuminated or fl ashing, turn the air conditioning off . |
NOTE
- When maximum cooling is desired, set the temperature control dial to the extreme cold position and set the air intake selector to the recirculated air position, then turn the fan control dial fully clockwise.
- If warmer air is desired at floor level,
set the mode selector dial at the
position and adjust the temperature control dial to maintain maximum comfort. - The air to the floor is warmer than air to the face (except when the temperature control dial is set at the extreme hot or cold position).
Ventilation
- Set the mode selector dial to the
position. - Set the air intake selector to the outside air position.
- Set the temperature control dial to the desired position.
- Set the fan control dial to the desired speed.
Heating
Set the mode selector dial to the
position.
Set the air intake selector to the outside
air position.
Set the temperature control dial to the
hot position.
Set the fan control dial to ...
Windshield Defrosting and
Defogging
Set the mode selector dial to the
position.
Set the temperature control dial to the
desired position.
Set the fan control dial to the desired
speed.
If dehumidified heating is desire ...
Other materials:
Front Drain Hose Installation
CAUTION:
If the front drain hose is pinched or bent anywhere, the water in the hose
may not discharge and enter the inside of the vehicle. During and after installation
of the trims and the headliner, always make sure there is no interference with
the front drain hose. Fix any probl ...
Oil Pressure Switch Inspection
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before removing the exhaust system.
1. Disconnect the negative battery cable..
2. Remove the aerodynamic under cover No.2..
3. Remove the oil pressur ...
Rear Tilt Motor Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable and wait 1 min or more..
3. Disconnect the rear tilt motor connector.
4. Apply battery positive voltage to the rear tilt motor terminals and inspect
the rear tilt motor operation
If not as specified, replace t ...
