1. Remove the windshield wiper arm and blade..
2. Remove the fastener A.
3. Pull the front fender molding in the direction of the arrow shown in the figure and remove it while remove the tab B and tab C.
4. Disconnect the windshield washer hose from the joint pipe A..
5. Remove the fasteners D.
6. Pull the cowl grille in the direction of arrow, then remove the tabs E from the windshield.
7. Remove the cowl grille.
8. Remove the fasteners.
9. Push the tab in the direction of arrow (1) shown in the figure, then remove the clips.
10. Remove the center cowl grille in the direction of arrow (2) shown in the figure.
11. Install in the reverse order of removal.
Unfastening the Seat Belt
Depress the button on the seat belt buckle.
If the belt does not fully retract, pull it out
and check for kinks or twists. Then make
sure it remains untwisted as it retracts.
NOTE
If a belt does not fully retract, inspect
it for kinks and twists. If it is still not
retracting properly, ...
Antenna Feeder No.4 Removal/Installation
Removal
NOTE:
The antenna feeder No.4 is integrated with the dashboard wiring harness.
1. Refer to DASHBOARD DISASSEMBLY/ASSEMBLY.
Installation
CAUTION:
If the antenna feeder No.4 is installed with tension on the cable and wiring
harness it could result in loosening of t ...
Seat Weight Sensor Inspection [Two Step Deployment Control System]
CAUTION:
If any of the following work is performed, perform the seat weight sensor
inspection using the M-MDS.
Removal of the passenger-side seat
Loosening and retightening of passenger’s seat fixing bolts
Or, the vehicle is involved in a collision
...