Mazda 3 Service Manual: Cruise Control Switch Inspection [Mzr 2.3 Disi Turbo]

Mazda 3 Service Manual / Accessories / Cruise Control / Cruise Control Switch Inspection [Mzr 2.3 Disi Turbo]

1. Remove the battery cover..

2. Disconnect the negative battery cable and wait for 1 min or more

3. Remove the driver–side air bag module..

4. Disconnect the clock spring connector (part wiring harness-side).

5. Measure the resistance between clock spring terminals K and M (part wiring harness-side) using a tester.

If not as specified, replace the steering switch..


Switch condition	Resistance (ohm)
Cruise OFF switch held at on	Continuity
CANCEL switch held at on	Approx. 120
SET (-) switch held at on	Approx. 300
SET (+) switch held at on	Approx. 600
RESUME switch held at on	Approx. 1,110
Cruise ON switch held at on	Approx. 2,110
Neutral	Approx. 4,310

6. Apply battery positive voltage to clock spring connector terminal O (part wiring harness-side), and terminal E (part wiring harness-side) to ground.

7. Verify that the LED illuminates.

If the LED does not illuminate, replace the steering switch..

Cruise Control Switch Inspection [Mzr 2.0, Mzr 2.5]

1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Remove the driver–side air bag module.. 4. Disconnect the clock spring connector (part wir ...

Electronics

...

Other materials:

Oil Pressure Switch Removal/Installation [FS5 A EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. 1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the aerodynamic under cover NO.2.. 2. Remove in t ...

Rear ABS Wheel Speed Sensor Inspection
Installation Visual Inspection 1. Inspect for the following: If there is any malfunction, replace the part. a. Excessive looseness or play of the rear ABS wheel-speed sensor b. Deformation of the rear ABS wheel-speed sensor c. Deformation or damage of the rear ABS sensor rotor C ...

Manual Transaxle Removal/Installation [G66 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...