Mazda 3 manuals

Mazda 3 Service Manual: Dashboard Upper Panel Removal/Installation

Mazda 3 Service Manual / Body / Body Interior / Dashboard Upper Panel Removal/Installation

Vehicles Without Bose®

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Upper column cover.

b. Instrument cluster.

c. Center panel.

d. Center cover.

3. Remove the screw.

4. Pull up the dashboard upper panel in the direction of arrow shown in the figure, then remove the clips.


5. Pull up the dashboard upper panel in the direction of arrow shown in the figure, then remove the clips.


6. Remove the dashboard upper panel.

7. Install in the reverse order of removal.

Vehicles With Bose®

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Upper column cover.

b. Instrument cluster.

c. Center panel.

d. Center cover.

3. Remove the screw.

4. Pull up the dashboard upper panel in the direction of arrow shown in the figure, then remove the clips.


5. Pull up the dashboard upper panel in the direction of arrow shown in the figure, then remove the clips.


6. Remove the dashboard upper panel.

7. Disconnect the center speaker connector.

8. Disconnect the microphone connector.

9. Remove the screws then remove the dashboard upper panel No.2 from the dashboard upper panel No.1.


10. Install in the reverse order of removal.

Dashboard Under Cover Removal/Installation
1. Detach the hooks in the direction of arrow (1) shown in the figure. 2. Pull the dashboard under cover in the direction of arrow (2). 3. Remove the dashboard under cover, then remove the gui ...

Decoration Panel Removal/Installation
1. Remove the following parts: a. Passenger-side front scuff plate. b. Passenger-side front side trim. c. Glove compartment. d. Passenger-side lower panel. 2. Remove the screw. 3. Pull the ...

Other materials:

Transaxle Oil Replacement [G66 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the drain plug and washer. 4. Drain the oil into a suitable container. 5. Install a new washer and the drain plug. Tightening torque 39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf} 6. Remo ...

How to Use Aha
Aha is an application which can be used to enjoy various Internet content such as Internet radio and podcasts. Stay connected to your friends activities by getting updates from Facebook and Twitter. Using the location-based service, nearby services and destinations can be searched or re ...

Air Fuel Ratio (A/F) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Remove the air clea ...

© 2016-2024 Copyright www.mazda3tech.com