Mazda 3 Service Manual: Data Network
- Body Control Module (Bcm) Configuration
- Body Control Module (Bcm) Inspection
- Body Control Module (Bcm) Removal/Installation
- Controller Area Network (Can) System
- On Board Diagnostic System PID/Data Monitor Inspection [FS5 A EL]
- On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL]
- On Board Diagnostic System Simulation Inspection [FS5 A EL]
- On Board Diagnostic System Simulation Inspection [Fw6 A EL]
- PID/Data Monitor Inspection [Bcm]
Ignition Switch Removal/Installation [Without Advanced Keyless Entry And Push
Button Start System]
1. Disconnect the negative battery cable..
2. Remove the column cover..
3. Detach the tab.
4. Pull the pin in the direction of the arrow shown in the figure and release
the lock.
5. ...
Body Control Module (Bcm) Configuration
1. Connect the M-MDS to DLC-2.
2. After the vehicle is identified, select the following items from the initial
screen of the M-MDS.
When using the IDS (laptop PC)
Select “ ...
Other materials:
Front Seat Rail Guide Cover Removal/Installation
WARNING:
Handling a front seat (with built-in side air bag) improperly can accidentally
operate (deploy) the air bag, which may seriously injure you. Read the service
warnings before handling a front seat (with built-in side air bag)..
CAUTION:
After removing a front seat ...
Throttle Position (TP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
Voltage Inspection
CAUTION:
The inspection cannot be performed with this method correctly if there is
a malfunction of the APP sensor or throttle valve actuator. Verify that no DTCs
related to the APP sensor or throttle valve actuator are stored before the inspection.
NOTE:
...
Schedule 1
U.S.A. residents - Engine oil flexible maintenance interval
Use when the maintenance monitor for “Oil Change” is set to “Flexible”. For
details, see maintenance monitor.
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
T: Tighten
Remarks:
...
