Keyless Entry System/Immobilizer System
Blind Spot Monitoring (BSM) System
NOTE During printing time of this user manual the approvals listed above are granted.
WARNING Change or modifi cations not expressively approved by the party responsible for compliance could void the use's authority to operate the equipment. |
HomeLink Wireless Control System
CAUTION HomeLink has been tested and complies with FCC and Industry Canada rules. Changes or modifi cations not expressly approved by the party responsible for compliance could void the user's authority to operate the device. |
NOTE
FCC ID: NZLMOBHL4
CANADA:4112A-MOBHL4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
Bluetooth® Hands-Free
Type A
U.S.A. and Canada
FCC ID: CB2MBLUEC09 IC:279B-MBLUEC09 This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
WARNING Changes or modifi cations not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. |
The term “IC: ” before the radio certification number only signifies that Industry Canada technical specifications were met.
The antenna used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
Mazda Bluetooth ® Hands-Free Customer Service
Mexico
Type B
U.S.A. and Canada
Mexico
Forward Obstruction Warning (FOW)/Mazda Radar Cruise Control (MRCC)
Drive Selection
Drive selection is a system to switch the vehicle's drive mode. When the
sport mode
is selected, vehicle's response against accelerator operation is enhanced. This
provides
additional quick acceleration which may be needed to safely make maneuvers such
as lane
changes, merging onto freeways ...
DSC HU/CM Removal/Installation
WARNING:
If the DSC HU/CM configuration is not completed, it could result in an unexpected
accident due to the DSC being inoperative. If the DSC HU/CM is replaced, always
use the automatic configuration function so that the DSC operation conditions
are correct.
If the DSC se ...
Discharge Headlight System Inspection
Discharge headlight inoperative
WARNING:
Incorrect servicing of the discharge headlight bulb could result in electrical
shock. Before servicing the discharge headlight bulb, always refer to the service
warnings..
Terminal layout
Inspection procedure
ST ...