Mazda 3 Owners Manual: Displayable Range on the Screen
The images on the screen may be different from the actual conditions.
NOTE
- The displayable range varies depending on the vehicle and road
conditions.
- The displayable range is limited. Objects under the bumper or around
the bumper ends
cannot be displayed.
- The distance appearing in the displayed image is different from the
actual distance
because the rear view parking camera is equipped with a specific lens.
- Some optionally installed vehicle accessories may be picked up by the
camera. Do not
install any optional parts that can interfere with the camera view, such as
illuminating
parts or parts made of reflective material.
- It may be difficult to see the display under the following
conditions, however, it does not
indicate a malfunction.
- In darkened areas.
- When the temperature around the lens is high/low.
- When the camera is wet such as on a rainy day or during periods of
high humidity.
- When foreign material such as mud is stuck around the camera.
- When the camera lens reflects sunlight or headlight beams.
- Image display may be delayed if the temperature around the
camera is low.
Switching to the Rear View Monitor Display
Shift the shift lever to R with the ignition switched ON to switch the
display to the rear view
monitor display.
NOTE
When the shift lever is shift ...
Guide lines which indicate the width of the vehicle (yellow) are displayed on
the screen as a
reference to the approximate width of the vehicle in comparison to the width of
the parking
space yo ...
Other materials:
Rear Washer Nozzle Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Rear spoiler.
c. High-mount brake light.
3. Disconnect the rear washer hose.
4. Press the tabs and remove the rear washer nozzle.
5. Install in the reverse order of removal.
6. Ad ...
Filament Inspection
1. Turn the ignition switch to the ON position.
2. Turn the rear window defroster switch on.
CAUTION:
Directly touching the rear window defroster filament with the lead of the
tester could damage it. Wrap aluminum foil around the end of the lead and inspect
the filament by touc ...
Crankshaft Position (CKP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
Removal
CAUTION:
When foreign material such as an iron chip is on the CKP sensor, it can cause
abnormal output from the sensor because of flux turbulence and adversely affect
the engine control. Be sure there is no foreign material on the CKP sensor when
replacing.
Do not a ...