1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Remove the front inner handle..
5. Inspect for continuity between the door lock switch terminals using an ohmmeter.
If not as indicated in the table, replace the door lock switch.
Door Sash Film Removal
1. Disconnect the negative battery cable.
2. Partially peel back the glass run channel.
3. Partially peel back the door weatherstrip.
4. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
d. Rear door trim.
e. Rear door speaker.
f. Rear door qu ...
Drive Belt Auto Tensioner Inspection [Mzr 2.0, Mzr 2.5]
MZR 2.0
1. Remove the generator drive belt with the A/C drive belt still installed and
set it out of the way..
2. Verify that the drive belt auto tensioner moves smoothly in the operational
direction.
If it does not move smoothly, replace the drive belt auto tensioner..
3. T ...
Body Control Module (Bcm) Removal/Installation
CAUTION:
When replacing the BCM, the configuration procedure must be performed before
removing the BCM. Replacing the BCM without performing the configuration procedure
will result in system malfunction.
ATX
1. Perform the BCM configuration when replacing it..
2. Disconnect t ...