1. Remove any grease or dirt from the affixing surface of the door.
2. Cut away the unused portion along the dotted lines.
3. Peel off the backing paper and attach the door sash film onto the door as shown in the figure.
a: 3.0—5.0 mm {0.12—0.19 in}
b: 3.0 mm or more {0.12 in or more}
c: 4.0—6.0 mm {0.16—0.23 in}
4. Peel off the transparent protective film on the door sash film.
5. Install the following parts:
a. Rear beltline molding.
b. Front beltline molding.
c. Rear door quarter glass.
d. Rear door speaker.
e. Rear door trim.
f. Power outer mirror.
g. Front door trim.
h. Inner garnish.
6. Connect the negative battery cable..
Door Adjustment
1. Loosen the door hinge installation bolts.
2. Adjust the gap and height difference to the standard range by moving the door
back and forth, left and right.
Standard range
a: 2.5―4.5 mm {0.10―0.17 in}
b: -1.0―1.0 mm {-0.039―0.039 in}
c: 2.5& ...
Starter Interlock Switch Inspection [Skyactiv G 2.0]
CAUTION:
Do not reuse the starter interlock switch if it is removed from the vehicle
even once. Replace with a new starter interlock switch when installing.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Disconnect the starter interlock switch connec ...
Caliper (Front) Disassembly/Assembly [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Disassemble in the order indicated in the table.
1
Bleeder cap
2
Bleeder screw
3
Piston
(See Piston Disassembly Note.)
(See Piston Assembly Note.)
4
Dust seal
(See Dust Seal ...