Mazda 3 manuals

Mazda 3 Service Manual: Doors/Lids & Hood/Trunk

Mazda 3 Service Manual / Body / Doors/Lids & Hood/Trunk

Body
...

Door Adjustment
1. Loosen the door hinge installation bolts. 2. Adjust the gap and height difference to the standard range by moving the door back and forth, left and right. Standard range a: 2.5 ...

Other materials:

Center Panel Removal/Installation
1. Disconnect the negative battery cable.. 2. Affix protective tape to the position shown in the figure. 3. Hold parts (A) shown in the figure with your hands and pull the lower edge of the center panel in the direction of the arrow (1), and remove clips A. CAUTION: Be careful no ...

Rear ABS Wheel Speed Sensor Inspection
Installation Visual Inspection 1. Inspect for the following: If there is any malfunction, replace the part. a. Excessive looseness or play of the rear ABS wheel-speed sensor b. Deformation of the rear ABS wheel-speed sensor c. Deformation or damage of the rear ABS sensor rotor C ...

ABS HU/CM Inspection
1. Disconnect the ABS HU/CM connector.. 2. Connect the negative battery cable.. 3. Attach the tester lead to the ABS HU/CM wiring harness-side connector and inspect the voltage, continuity, or resistance according to the standard (reference value) in the table below. Standard (reference) ...

� 2016-2026 Copyright www.mazda3tech.com