NOTE:
Drive belt deflection/tension inspection is not necessary because of the use of the drive belt auto tensioner.
1. Verify that the drive belt auto tensioner indicator mark does not exceed the limit.
If it exceeds the limit, replace the drive belt..
Ignition Coil Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the charge air cooler..
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
1
Connector
2
Ignition coil
...
Climate Control Unit Disassembly/Assembly [Manual Air Conditioner]
1. Disassemble in the order indicated in the figure.
1
Dial
2
Airflow mode wire
(See Wire Removal Note.)
(See Wire Installation Note.)
3
Air mix wire
(See Wire Removal Note.)
(See Wire Installation Note ...
Front Door Hinge Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front bumper.
b. Front combination light.
c. Front fender molding.
d. Side step molding.
e. Front fender panel.
f. Front door.
3. Remove in the order indicated in the table.
1
B ...