Generator Drive Belt
NOTE:
The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner.
1. Verify that the indicator part of the cast hexagon on the drive belt auto tensioner is within the normal range.
If it exceeds the limit, replace the drive belt..
Water Pump Drive Belt
NOTE:
The water pump drive belt deflection/tension inspection is not necessary with the adoption of the stretch-type water pump drive belt.
1. Visually inspect or feel that there is no wear, damage, or cracking on the inside and sides of the entire the belt.
Even if there is a little wear, damage, or cracking, replace the water pump drive belt..
2. Start the engine to verify that abnormal noise does not occur.
If abnormal noise occurs, replace the water pump drive belt..
Generator Disassembly/Assembly [Mzr 2.0, Mzr 2.5]
CAUTION:
Melt the solder quickly, otherwise the diodes (rectifier) and regulator will
be damaged by excessive heat.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
MZR 2.0
1
Rotor component
...
Drive Shaft Inspection
1. Inspect the connections for any looseness.
If there is any malfunction, tighten or replace the applicable part.
2. Inspect the dust boot for damage and cracks.
If there is any malfunction, replace the applicable part.
3. Move the spline and joint up and down, left ...
Auxiliary Jack/Usb Port
NOTE:
“iPod” is a registered trademark of Apple Inc. in the United States and other
countries.
Purpose, Function
The Auxiliary jack/USB port outputs the audio signals of commercially-available
portable audio, a USB device, or an iPod connected to the Auxiliary jack/USB
...