Generator Drive Belt
NOTE:
The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner.
1. Verify that the indicator part of the cast hexagon on the drive belt auto tensioner is within the normal range.
If it exceeds the limit, replace the drive belt..
Water Pump Drive Belt
NOTE:
The water pump drive belt deflection/tension inspection is not necessary with the adoption of the stretch-type water pump drive belt.
1. Visually inspect or feel that there is no wear, damage, or cracking on the inside and sides of the entire the belt.
Even if there is a little wear, damage, or cracking, replace the water pump drive belt..
2. Start the engine to verify that abnormal noise does not occur.
If abnormal noise occurs, replace the water pump drive belt..
Control Valve Body Removal/Installation [Fw6 A EL]
On-Vehicle Removal
WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait
until they are cool.
Using compressed air can cause dirt and other particles to fly out, causing
injury to the eyes. Wear protective eyeglasses whenever using compressed ai ...
Crankshaft Position (CKP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
Visual Inspection
CAUTION:
When foreign material such as an iron chip is on the CKP sensor, it can cause
abnormal output from the sensor because of flux turbulence and adversely affect
the engine control. Be sure there is no foreign material on the CKP sensor when
replacing.
...
Rear Outer Handle Removal/Installation
1. Fully close the rear door glass.
2. Disconnect the negative battery cable..
3. Remove the rear door trim..
4. Remove the service hole cover.
5. Remove the screw from the service hole.
NOTE:
The screw cannot be removed because of the stopper.
6. Press the tab on the ...