Mazda 3 Service Manual: Driver Info & Control

Horn Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the connector. 4. Remove the bolt. 5. Remove the horn. 6. Install in the reverse order of removal. ...

Active Command Modes Inspection [Instrument Cluster]

1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Module ...

Other materials:

Starter Interlock Switch Inspection [Mzr 2.0, Mzr 2.5]
CAUTION: Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the starter interlock switch connec ...

Schedule 1
Chart symbols: I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary. R: Replace L : Lubricate T: Tighten Remarks: *1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL-22 may cause serious damage to the engine and c ...

Engine Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin ...